Assembly Instructions

Assembly Steps:

PDF download, pictures, and videos coming soon.

Print parts.
Put felt in hoop.
Spray glue and lay billiard felt.
Cut felt around board edge.
Put rim on to hold felt in place as it dries.
Cut hole, stab it, then cut it into 6 pieces.
Prep hole insert to fit into hole retainer, this can be a real snug fit at times.
Insert hole printed part.
Make sure magnets are all properly aligned polarities.
Glue in magnets.

Print parts
Clear holes of print debrief, poke with allen key
insert square nuts into all squares.
Center end square nuts by pushing them into the slot
Screw m3 screw into square nuts to pull them to inside edge
Attach each side of ramp to each other with m12 screws
insert m3 6mm screws into the 4 middle square nuts
cut 4 inches of fishing line
wrap fishing line around first screw, screw in
run line under bell bar and wrap around
cross line into a knot and pull tight
wrap other end if line around other side of screw, keep tight, tighten screw in. Keep it as tight as you can without breaking the line.
make sure bell is center or center it
repeat with next bell mount with the center m3 6mm screws
if installed correctly, and bell is not hitting any solid edge, only suspended inbetween, you can make it ding with relative ease
center bell as needed

Center bell in between ball return rear
use m3 6mm screws to mount rear return. if needed use a 12mm screw to pull it into place and then replace with the 6mm
use m3 12mm screws to mount ramp to front.
recommend an allen wrench with a ball end for this side as the screws have to angle upward
just get the ramp and its square nuts to hit the screws and start threading, using threading it to pull the ramp in to the slot
make sure to align the ramp so that it lies at the proper horizontal 5 degree incline angle
turn ramp upside down to make sure it clears and lays flat
make sure ramp lays flat right side up
make sure magnets are aligned polarities, glue in magnets